Ir para o conteúdo principal

Alterações no passo #5

Edição por Nicolas Siemsen

Edição aprovada por Nicolas Siemsen

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Inspect the shaft closely. As you can see here there is sufficient dirt and other contaminants to prevent a good seal, hence the leak.
[* black] Clean the piston shaft, then carefully remove the two rubber seals with a small flat blade screw driver or pick to clean underneath.
[* black] Re-install the seals on the shaft.
+[* black] Lubricate the shaft with a silicone grease that is safe on rubber.