Conserte seus objetos Comunidade Loja

Alterações no passo nº 2

Edição por Sam Goldheart —

Edição aprovada por Sam Goldheart

Antes
Depois
Sem alteração

Linhas do passo

[* black] Use the tip of a spudger to pry the ringer switch bracket from the side of the rear case.
[* black] Remove the ringer switch.
- [* icon_reminder] Note the orientation for reassembly: The red line should be up, and when you're fitting the switch bracket back onto the switch, ensure the switch and actuator are in the same position and connected.
+[* icon_reminder] Note the orientation for reassembly: The red line should be at the top of the button. The notch in the back of the hold button cover should be in the same position as, and mate with, the mechanical switch on the cable.