Alterações no passo nº 9
Edição por midiman127 —
Edição aprovada por midiman127
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* black] Place circuit board back into the casing and attach all screws. |
|---|---|
| + | [* black] If positioned correctly the rubber band will make connection between the new LCD and the board. |
| + | [* black] Push the wires back between the side casing and the circuit board. The order is now reversed: 1st Black, 2nd Orange, 3rd White. |
| + | [* black] Re-attach all connectors onto the circuit board except the flash base. |
| + | [* black] Insert batteries and hold the cap closed with your fingers. It will not snap closed until the casing is back together. |
| + | [* black] Turn on the flash and check if the LCD works. Push the back-light button (above Pilot) to make sure it works. |
| + | [* black] After the test remove batteries. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado