Histórico do passo nº 7 do guia Canon Speedlight 430EX II LCD Replacement

Alterações no passo nº 7

Edição por midiman127 — 21 de nov de 2013

Edição aprovada por midiman127

+	[title] Remove old LCD
	[* black] Remove 5 screws holding the circuit board.
	[* black] Remove screw holding metal tab. The screw is different than other 5. Make sure you leave it in the tab.
	[* black] Remove screw holding plastic cap. Keep screw in the cap as it is a different size.
	[* black] Take the circuit board out of the casing flipping it over.
	[* black] There is a clear plastic plate (red) between the LCD and the circuit board. It might fall out. It is used to distribute the back-light.
-	[* ~~black~~] Pull the old LCD off carefully. Make sure not to tear the rubber band (green). This is used to transfer the signals from the board to the LCD.
+	[* icon_caution] Pull the old LCD off carefully. Make sure not to tear the rubber band (green). This is used to transfer the signals from the board to the LCD.