Alterações no passo nº 7
Edição por midiman127 —
Edição aprovada por midiman127
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* black] Remove 5 screws holding the circuit board. |
|---|---|
| + | [* black] Remove screw holding metal tab. The screw is different than other 5. Make sure you leave it in the tab. |
| + | [* black] Remove screw holding plastic cap. Keep screw in the cap as it is a different size. |
| + | [* black] Take the circuit board out of the casing flipping it over. |
| + | [* black] There is a clear plastic plate (red) between the LCD and the circuit board. It might fall out. It is used to distribute the back-light. |
| + | [* black] Pull the old LCD off carefully. Make sure not to tear the rubber band (green). This is used to transfer the signals from the board to the LCD. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado