Alterações no passo nº 2
Edição por Griffin Paul —
Edição aprovada por Griffin Paul
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Starting at the wide base of the triangular sections, use the 10 mm nuts and bolts to attach two solar panel plates together. First hand tighten each bolt/nut pair, then secure them with your two 10 mm wrenches. | |
| - | [* red] On the way to the center, |
| + | [* red] On the way to the center, DO NOT install a nut and bolt in the ***THIRD TO LAST*** drill hole. This is where you will attach the Pipe Ring Brackets later on. |