Ir para o conteúdo principal

Alterações no passo #1

Edição por Sean Brannon

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* icon_note] The screw circled in orange may not be present in some models.
[* black] Remove the following 16 screws:
[* red] Thirteen 3 mm Phillips.
[* orange] One 3 mm Phillips. (actual screw not present in image)
[* yellow] Two 4 mm Phillips.
[* icon_reminder] Be sure to fit the screw near the left hinge through the loop in the display data cable, securing the cable to the upper case.
[* icon_caution] Missing in this photo is the Bluetooth antenna present in some iBooks. It is located at the upper right corner of the battery compartment, just above and to the left of the 4mm screw. In the photo youYou can see two I-shaped holes in the shield. This is the bracket for the Bluetooth antenna. Slide the antenna towardsin the display, and lift it fromphoto. It is the shield. Intwo I-shaped holes just above the next step, where4mm screw that must be removed in this step. To remove the shield is removed, you must carefullyantenna, slide it toward the Bluetooth antenna through the lower I-shaped hole of its bracketLCD, and tilt it vertically back towards yourself.
[* icon_caution] Missing in this photo is the Bluetooth antenna present in some iBooks. It is located at the upper right corner of the battery compartment, just above and to the left of the 4mm screw. In the photo youYou can see two I-shaped holes in the shield. This is the bracket for the Bluetooth antenna. Slide the antenna towardsin the display, and lift it fromphoto. It is the shield. Intwo I-shaped holes just above the next step, where4mm screw that must be removed in this step. To remove the shield is removed, you must carefullyantenna, slide it toward the Bluetooth antenna through the lower I-shaped hole of its bracketLCD, and tilt it vertically back towards yourself.