| - | [* black] Если вы вставите тестовую плату так, как на фото, тогда: D- и D+ это контакты USB2.0 части разъёма А2,А3 + А10,А11 + В2,В3 + В10,В11 это TX и RX пары USB3.0 части |
|---|
| - | [* black] The TX and RX pairs of USB 3.0 should be the same in both directions and be 550..650 during diode ringing in both directions |
|---|
| + | [* black] If you insert the test board as shown in the photo, then: D- and D+ are the pins of the USB2.0 part of the connector A2,A3 + A10,A11 + B2,B3 + B10,B11 are the TX and RX pairs of the USB3.0 part |
|---|
| + | [* black] The TX and RX pairs of USB 3.0 should be the same in both directions and A10-A11 & B10-B11 must be 600+\- during diode ringing in both directions |
|---|