Alterações no passo nº 12
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Press the tip against the second ***R2*** solder pad and the resistor's second end cap for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and cap. | |
| [* black] Feed the solder wire into the heated area until there's a small glob of solder surrounding the second end cap. | |
| - | [* black] Remove the solder wire first, then remove the soldering iron from the pad. |