Alterações no passo nº 8
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* icon_note] In this step, you're going to heat the solder pad and the resistor's end cap so that they'll readily melt the solder wire. | |
| [* black] Press the tip against the second ***R4*** solder pad and the resistor's second end cap for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and cap. | |
| [* icon_caution] If you heat the circuit board continuously for more than 10 seconds, the excessive heat may damage the solder pad or resistor. | |
| [* black] Feed the solder wire into the heated area until there's a concave pool of solder surrounding the end cap. | |
| - | [* icon_note] Don't feed the solder directly onto the tip as it won't flow properly into the pad and lead, causing a weak connection. |
| [* black] Remove the solder wire first, then remove the soldering iron from the pad. |