Alterações no passo nº 7
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Place the largest 10 kΩ resistor (labeled 103) in the outline labeled "R4" on the board. | |
| [* icon_note] For a handy surface-mount resistor value calculator, [link|https://kiloohm.info/smd3-resistor/683|click here|new_window=true]. All the resistors in this kit are 3 digit EIA (Electronic Industries Alliance). | |
| [* black] Re-heat the solder while holding the resistor in its outline, so that its end caps (the shiny parts) are resting on the circuit board's pads. | |
| + | [* icon_note] The resistor is symmetrical and can be soldered in either orientation. |
| [* black] Remove the iron, then remove the tweezers once the solder has cooled. |