Alterações no passo nº 26
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Press the tip against the |
|---|---|
| + | [* black] Press the tip against the power inductor's second solder pad and the power inductor's second end cap for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and cap. |
| [* black] Feed the solder wire into the heated area until there's a concave pool of solder joining the second end cap to its pad. | |
| [* icon_note] The power inductor's contact pads are underneath it, so the solder joint doesn't need to cover the entire end. |