Alterações no passo nº 20
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* icon_caution] This process is both difficult and time-consuming. ***Take your time*** and ***be extra careful*** not to overheat the solder pads or leads. Avoid using |
|---|---|
| + | [* icon_caution] This process is both difficult and time-consuming. ***Take your time*** and ***be extra careful*** not to overheat the solder pads or leads. Avoid using desoldering wick to desolder the leads, as it could easily destroy the pads. |
| [* black] Press the tip against another solder pad and feed the solder wire into the heated area until there's a concave pool of solder contacting the pin. | |
| - | [* icon_note] Check if any solder unintentionally bridged with a different joint. If so, carefully use your iron to heat the solder between the joints and separate the bridge. If the bridge doesn't want to separate, [guide|173873|desolder|stepid=370734|new_window=true] |
| + | [* icon_note] Check if any solder unintentionally bridged with a different joint. If so, carefully use your iron to heat the solder between the joints and separate the bridge. If the bridge doesn't want to separate, [guide|173873|desolder it using a desoldering pump|stepid=370734|new_window=true] and try again. |
| [* black] Repeat this process for all of the remaining microcontroller pins. |