Alterações neste passo
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [title] Solder C3 |
|---|---|
| [* black] Place the smaller 22 nF capacitor (with no label on its packaging) in the outline labeled "R4" on the board. | |
| [* black] Re-heat the solder while holding the capacitor in its outline, so that its end caps (the shiny parts) are resting on the circuit board's pads. | |
| [* black] Press the tip against the second C3 solder pad and the capacitor's second end cap for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and cap. | |
| [* black] Feed the solder wire into the heated area until there's a concave pool of solder surrounding the end cap. | |
| [* black] Remove the solder wire first, then remove the soldering iron from the pad. |