Alterações no passo nº 25
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Solder the power inductor |
|---|---|
| [* black] Press the iron's tip against the circuit board's "L1" solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a concave pool of solder on the pad. | |
| [* black] Re-heat the solder while holding the inductor in its outline, so that its end caps (the sides with the notches) are resting on the circuit board's pads. | |
| [* black] Remove the iron, then remove the tweezers once the solder has cooled. |