Histórico do passo nº 15 do guia Mini Digital Oscilloscope DIY Soldering Kit Assembly

Alterações no passo nº 15

Edição por Nick Schultz — 8 de nov de 2024

Edição aprovada por Nick Schultz

	[title] Solder the LED
	[* black] Press the iron's tip against the circuit board's *LED* solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a small glob of solder on the pad.
	[* black] Place the LED in the outline labeled *LED* on the board, with the white (non-green) side aligned with the "*+*" symbol.
	[* icon_note] The green markings indicate the negative (*-*) side.
+	[* black] Solder the LED's first end cap to the board.
+	[* icon_note] The LED's contact pads are underneath it, so the solder joint doesn't need to cover the entire end.