Histórico do passo nº 15 do guia Mini Digital Oscilloscope DIY Soldering Kit Assembly - iFixit

Alterações no passo nº 15

Edição por Nick Schultz — 4 de nov de 2024

Edição aprovada por Nick Schultz

: Antes
: Depois
: Sem alteração

Linhas do passo

	[title] Solder the LED
-	[* black] Press the iron's tip against the circuit board's "LED" solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a concave pool of solder on the pad.
-	[* black] Place the LED in the outline labeled "LED" on the board, with the white (non-green) side aligned with the "*+*" symbol.
+	[* black] Press the iron's tip against the circuit board's *LED* solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a concave pool of solder on the pad.
+	[* black] Place the LED in the outline labeled *LED* on the board, with the white (non-green) side aligned with the "*+*" symbol.
	[* icon_note] The green markings indicate the negative (*-*) side.