Alterações no passo nº 15
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Solder the LED |
|---|---|
| + | [* black] Press the iron's tip against the circuit board's solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a concave pool of solder on the pad. |
| + | [* black] Place the LED in the outline labeled "LED" on the board, with the white (non-green) side aligned with the "***+***" symbol. |
| + | [* icon_note] The green markings indicate the negative (***-***) side. |