Alterações no passo nº 11
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Place the smaller 10 kΩ resistor ([link|https://guide-images.cdn.ifixit.com/igi/QAvScuPhTg1NBfPU.full|labeled 103|new_window=true]) in the outline labeled ***R2*** on the board. | |
| [* black] Press the soldering iron's tip onto the edge of the solder pad while holding the resistor in its outline, so that its end caps (the shiny parts) are resting on the circuit board's pads. | |
| + | [* black] Remove the iron, then remove the tweezers once the solder has cooled. |