Conserte seus objetos Comunidade Loja

Alterações no passo nº 11

Edição por Nick Schultz —

Edição aprovada por Nick Schultz

Antes
Depois
Sem alteração

Linhas do passo

[title] Solder the second resistor
[* black] Place the smaller 10 kΩ resistor (labeled 103) in the outline labeled "R2" on the board.
-[* black] Press the soldering iron tip against the circuit board's solder pad and the resistor's conductive edge for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and _.
-[* black] Feed the solder wire into the heated area until there's a concave pool ("mini volcano") of solder surrounding the conductive edge.
- [* icon_note] Don't feed the solder directly onto the tip as it won't flow properly into the pad and _, causing a weak connection.
+[* black] Press the soldering iron tip against the circuit board's solder pad and the resistor's first end cap for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and cap.
+[* black] Feed the solder wire into the heated area until there's a concave pool ("mini volcano") of solder surrounding the end cap.
+ [* icon_note] Don't feed the solder directly onto the tip as it won't flow properly into the pad and cap, causing a weak connection.
[* black] Remove the solder wire first, then remove the soldering iron from the pad.
-[* black] Repeat this process for the other _
+[* black] Repeat this process for the resistor's second end cap.