Alterações no passo nº 11
Edição por Nick Schultz —
Edição aprovada por Nick Schultz
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Solder the second resistor |
|---|---|
| [* black] Place one of the 2 kΩ resistors (labeled 202) in the outline labeled "R1" on the board. | |
| [* black] Press the soldering iron tip against the circuit board's solder pad and the resistor's conductive edge for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and _. | |
| [* black] Feed the solder wire into the heated area until there's a concave pool ("mini volcano") of solder surrounding the conductive edge. | |
| [* icon_note] Don't feed the solder directly onto the tip as it won't flow properly into the pad and _, causing a weak connection. | |
| [* black] Remove the solder wire first, then remove the soldering iron from the pad. | |
| [* black] Repeat this process for the other _ |