Histórico do passo nº 4 do guia Mini Digital Oscilloscope DIY Soldering Kit Assembly

Alterações no passo nº 4

Edição por Nick Schultz — 16 de out de 2024

Edição aprovada por Nick Schultz

	[* black] Set down the circuit board on your work mat/surface so the front (the side labeled "MiNi-DSO" at the top) is facing up.
-	[* black] Place ~~one of~~ the 2 kΩ ~~resistors~~ (labeled ~~202~~) in the outline labeled "R1" on the board.
+	[* black] Place the largest 10 kΩ resistor (labeled 103) in the outline labeled "R4" on the board.