Conserte seus objetos Comunidade Loja

Alterações no passo nº 4

Edição por Connor —

Edição aprovada por Connor

Antes
Depois
Sem alteração

Linhas do passo

[title] Remove Excess Solder
-[* black] After the entire working surface of the iron tip has been coated with solder, clean off any excess solder with your brass sponge or damp cellulose sponge.
-[* icon_note] "Stabbing" the brass sponge or wiping the tip with a damp sponge a few times should do the job.
+[* black] After the entire working surface of the iron tip has been coated with solder, clean off any excess solder with your brass or damp cellulose sponge.
+[* icon_note] "Stabbing" the brass sponge, or wiping the tip with a damp cellulose sponge a few times should do the job.
[* black] Whether you're actively soldering or about to store your iron, you should ''always'' keep your tip tinned for these two reasons:
[* icon_note] A tinned tip transfers heat much more effectively, making soldering a breeze.
[* icon_note] The coat of solder creates a barrier between the tip and environment, dramatically reducing the rate of oxidation.