Alterações no passo nº 2
Edição por oldturkey03 —
Edição aprovada por oldturkey03
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* black] RElease the small clips holding the lower part of the motherboard to the bezel, the upper part is glued to the front panel. Gently pry upwards with an opening tool to release the glue.Once the logic board is loose, flip it to the left since its ribbov cable is still connected. Remove the Kapton tape. |
|---|---|
| + | [* black] Loosen the clamp connector by gently pulling it up. Heat Glass with either hairdryer or heatgun to loosen the glue that holds the digitizer to the front bezel. Keep the heatsource moving so as to evely heat the glue |
| + | [* black] Once the glue loosens use a plastci pry tool to pry the glass from the bottom edge and work your way around it.Do not insert the opening tool to deep. this could damage the LCD.It may be necessary to reheat the screen to further loosen the adhesive.Remove any bits of glass and debris from teh frame. |
| + | [* black] New line. |