Alterações no passo nº 12
Edição por Sarah Westberg —
Edição aprovada por Sarah Westberg
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Secure the table back onto the stand by turning all the screws halfway first, then tightening them completely. |
|---|---|
| - | [* black] Screw the hold tube back in place. |
| - | [* icon_note] Make sure the hold tube is facing the right direction before screwing the table on. |
| + | [* black] Use a Phillips #2 screwdriver to replace the eight 15.2 mm screws securing the table to the stand. |
| + | [* icon_note] Turn all the screws halfway first, then tighten them completely. |
| + | [* black] Use a Phillips #2 screwdriver to replace the two 15.2 mm screws that secure the hand crank. |
| + | [* icon_note] Make sure the handle is facing the correct direction before replacing the screws. |