Conserte seus objetos Comunidade Loja

Alterações no passo nº 5

Edição por Natalie Villasenor —

Edição aprovada por Natalie Villasenor

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Cut the wires as close to the pump as possible, to preserve their length. The wire connections are covered with glue
-[* black] Strip the plastic from about 1/8 inch of the wire ends.
-[* black] On the circuit board, note which wire is positive, and which wire is negative.
+[* black] Cut the wires as close to the pump as possible, to preserve the length of the wire. The wire connections are covered with glue.
+[* black] Strip the plastic that covers the wire about 1/8 inch down from the ends until the end of the wire is exposed.
+[* black] On the circuit board, note which wire is positive and which wire is negative.