Conserte seus objetos Comunidade Loja

Alterações no passo nº 3

Edição por Ivan G de la Rosa —

Edição aprovada por Ivan G de la Rosa

Antes
Depois
Sem alteração

Linhas do passo

[title] Release the Cartridge Reader
-[* black] To release the cartridge reader look for 4 solder points, 2 on each side of the reader (see image) and apply heat to them to melt the solder and take out the reader. Use a spludger to lift the reader out of the board as you apply heat .
+[* black] To release the cartridge reader look for 4 solder points, 2 on each side of the reader (see image).
+[* black] Apply heat to them with a soldering iron to melt the solder and take out the reader. Use a spludger to lift the reader out of the board as you apply heat.
[* black] You can apply some solder flux or even some new solder wire to form an alloy between the old and new metals, this would ease the task.
-[* icon_caution] CAUTION: soldering iron can cause severe burns if not used properly, proceed with caution and have an adult in the room with you if underage.
+[* icon_caution] CAUTION: Soldering iron can cause severe burns if not used properly, proceed with caution and have an adult in the room with you if underage.