Conserte seus objetos Comunidade Loja

Alterações no passo nº 3

Edição por Gwen —

Edição aprovada por Kelsea Weber

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Take notice of this small white cylinder, it may be hard to see as it is behind several wires.
+[* black] To the far left of the wiring is a small metal hook. There is a plastic cylinder by the hook . This hook needs to wrap over the white cylinder for a full electrical circuit to be complete.
[* black] You will need to make space for it and bring it out towards you.
-[* black] Notice that there are 2 little plastic tabs that block the cylinders body. You will need to depress them and then push the cylinder body out towards you.
-[* black] Use caution in order to not touch the metal connected to the flash and to not break the insulation of a wire as both could electrocute you. Note that this can still occur even if the battery has been removed.
+[* black] Notice that there are 2 little plastic tabs that block the cylinder body. You will need to depress them and then pull the cylinder body out towards you.
+[* black] CAUTION: Do not touch any metal on the camera while repairing the flash. Even though the battery is removed, the capacitor can give you quite a zap. not break the insulation of a wire as both could electrocute you. Also, be very careful not to damage any wires.