Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #15

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Starting the repair: Removing the old capacitors
[* black] Put the soldering iron on the points where the old capacitors are soldered, while pushing on the capacitor to remove iticon_caution] This guide does not touching the soldering iron. Removal of the old capacitors doesn't haveteach you how to be pretty, because we will remove the old solder. If you need a guidehow to on soldering, refer to this guide: [guide|750]
[* icon_reminder] The best way to avoid touchingblack] Take the soldering iron isboard out to use a grip or liftingplace you can solder the boardnew caps on. To remove the old capacitors from the board, heat one lead up whereat a time and pull the capacitor out. Do this for all of the capacitors you are changing. Since the spot will be cleaned up, removal does not have to be clean.
[* icon_reminder] Do not touch
the soldering iron while removing the old caps! Hold the board at an angle you will not accidentally touch your soldering iron and your hand is away from your handthe tip of the iron.
[* icon_note] Even if you only have to replace one cap on the board,failed capacitor, it is better to change all of them. If you should replacechange them all in one shot as preventive maintenance. If you use the monitor with new and original caps, then the ones that did not fail beforego, they will end up causing you grief in the future. This will happenall keep failing until all of the capacitorsthem are replaced. It's better to do this once rather then keep having to do it.
[* black] Put the soldering iron on the points where the old capacitors are soldered, while pushing on the capacitor to remove iticon_caution] This guide does not touching the soldering iron. Removal of the old capacitors doesn't haveteach you how to be pretty, because we will remove the old solder. If you need a guidehow to on soldering, refer to this guide: [guide|750]
[* icon_reminder] The best way to avoid touchingblack] Take the soldering iron isboard out to use a grip or liftingplace you can solder the boardnew caps on. To remove the old capacitors from the board, heat one lead up whereat a time and pull the capacitor out. Do this for all of the capacitors you are changing. Since the spot will be cleaned up, removal does not have to be clean.
[* icon_reminder] Do not touch
the soldering iron while removing the old caps! Hold the board at an angle you will not accidentally touch your soldering iron and your hand is away from your handthe tip of the iron.
[* icon_note] Even if you only have to replace one cap on the board,failed capacitor, it is better to change all of them. If you should replacechange them all in one shot as preventive maintenance. If you use the monitor with new and original caps, then the ones that did not fail beforego, they will end up causing you grief in the future. This will happenall keep failing until all of the capacitorsthem are replaced. It's better to do this once rather then keep having to do it.