Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #15

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Starting the repair: Removing the old capacitors
[* black] Put the soldering iron on the points where the old capacitors are soldered, while pushing on the capacitor to remove it not touching the soldering iron. Removal of the old capacitors doesn't have to be pretty, because we will remove the old solder. If you need a guide on soldering, refer to this guide: [guide|750]
[* icon_reminder] The best way to avoid touching the soldering iron is to use a grip or lifting the board up where the soldering iron is away from your hand.
[* icon_note] A full recapEven if you only have to replace one cap on the board, you should be performedreplace them all in one shot as preventive repair work now. Untilmaintenance. If you replaceuse the monitor with new and original caps, then the ones that did not fail before will end up causing you grief in the future. This will happen until all of the capacitors they will continue to fail until they are all replaced. This is especially common with low quality capacitors like CapXon.
[* icon_note] A full recapEven if you only have to replace one cap on the board, you should be performedreplace them all in one shot as preventive repair work now. Untilmaintenance. If you replaceuse the monitor with new and original caps, then the ones that did not fail before will end up causing you grief in the future. This will happen until all of the capacitors they will continue to fail until they are all replaced. This is especially common with low quality capacitors like CapXon.