Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #12

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[* black] As you keep that plate lifted up, maneuver the shield covering the power suppy and control boards up. After you have this removed, identify the power supply.
[* black] After you identify the bad capacitor, '''make sure you get the right one, or the capacitor will explode when the monitor is turned on'''.
[* icon_note] You can go up in voltage and uF ratings as much as you want, but the new capacitors have to fit in place where the old capacitor is. Capacitors as of 2013(when I did this) are much smaller then the factory ones, so you can go over more easily and fit them now. '''You can not go under on uF or voltage, or the capacitor will explode.'''
[* icon_note] The original capacitors Acer used go as follows:2x 25V 1000uF capacitors, 1x 10V 1000uF capacitor, 2x 25V 220uF capacitors if you intend to match the factory specified capacitor ratings. If you double them, make sure you exceed the original uF and voltages and not go under or they will fail when the monitor is turned on.
[* icon_caution] '''If any of the capacitors have bulged, they may still have a charge. Handle the power supply with extreme caution if any capacitors are bulgedcaution!'''
[* icon_caution] '''If any of the capacitors have bulged, they may still have a charge. Handle the power supply with extreme caution if any capacitors are bulgedcaution!'''