Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #12

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Remove the power supply
[* icon_caution] '''''If you see bulged capacitors, assume there is a residual charge.'''''
[* icon_caution] '''''If the filter capacitor is replaced, IT MUST BE DISCHARGED. In addition, the black screw (Blue) is a ground screwground.'''''
[* red] This capacitor is only found on older power supplies. '''''Replacement is not requiredrecommended, but recommendednot required.'''''
[* icon_caution] '''''If the filter capacitor is replaced, IT MUST BE DISCHARGED. In addition, the black screw (Blue) is a ground screwground.'''''
[* red] This capacitor is only found on older power supplies. '''''Replacement is not requiredrecommended, but recommendednot required.'''''
[* black] With the power supply shield removed from the monitor, identify the power supply. '''''Take note of the values, including the inverter cap if present.'''''
[* black] Remove the 4 screws from the power supply. Once this is done, lift up the power supply at a slight angle to clear the chassis. '''''Do not lift too much or the connector may be damaged!'''''