Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #12

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Remove the power supply
[* icon_caution] '''''If you see bulged capacitors, treat the power supply as if the capacitors are holding a residual charge.'''''
[* icon_caution] '''''If the filter capacitor is replaced, IT MUST BE DISCHARGED. In addition, the black screw (Blue marker) is for grounding and cannot be lost.'''''
[* icon_caution] Only lift the power supply board at a slight angle. Lifting it any higher may damage the processing board or interface.
[* icon_reminder] '''''If you cannot find the original capacitors, the original parts can be safely substituted.'''''
[* icon_note] (Red)red] This capacitor is only found on older power supplies. '''''Replacement is not required, but recommended.'''''
[* icon_reminder] '''''If you cannot find the original capacitors, the original parts can be safely substituted.'''''
[* icon_note] (Red)red] This capacitor is only found on older power supplies. '''''Replacement is not required, but recommended.'''''
[* black] With the power supply shield removed from the monitor, identify the power supply. '''''Take note of the values, including the inverter cap if present.'''''
[* black] Remove the 4 screws from the power supply. Once this is done, lift up the power supply at a slight angle to clear the chassis.