Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #12

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Remove the power supply
[* icon_caution] '''''If you see bulged capacitors, treat the power supply as if the capacitors are holding a residual charge.'''''
[* icon_caution] '''''In most cases, the filter capacitor is okay. It MUST be discharged if being replaced. In addition, the black screw (Blue marker) is a grounding screw and cannot be lost.'''''
[* icon_remindericon_caution] Only lift the power supply board at a slight angle. Lifting it any more then this could result in pin or video processing board damage.
[* icon_reminder] If'''''If you cannot find the original capacitors, it is safe to substitute for '''''greater value parts.''''' '''''It is not necessary to match the capacitors used by the factoryoriginal parts can be safely substituted.'''''
[* red] This capacitor is only used on older power supply boards. '''''If your board has this capacitor, replacement is recommended, but not required unless there is obvious bulging or leakageit should be repalced. However, it can be left alone if it looks okay.'''''
[* black] With the power supply shield removed from the monitor, identify the power supply. Along with the capacitors previously mentionedlisted capacitors, take note of any additional capacitors that were not mentionedothers you want to replace (Ex: inverterInverter coil).
[* black] Remove the 4 screws from the power supply. Once this is done, lift up the power supply up at a slight angle to clear the chassis mounting holes on the monitor chassis for removalholes.
[* icon_remindericon_caution] Only lift the power supply board at a slight angle. Lifting it any more then this could result in pin or video processing board damage.
[* icon_reminder] If'''''If you cannot find the original capacitors, it is safe to substitute for '''''greater value parts.''''' '''''It is not necessary to match the capacitors used by the factoryoriginal parts can be safely substituted.'''''
[* red] This capacitor is only used on older power supply boards. '''''If your board has this capacitor, replacement is recommended, but not required unless there is obvious bulging or leakageit should be repalced. However, it can be left alone if it looks okay.'''''
[* black] With the power supply shield removed from the monitor, identify the power supply. Along with the capacitors previously mentionedlisted capacitors, take note of any additional capacitors that were not mentionedothers you want to replace (Ex: inverterInverter coil).
[* black] Remove the 4 screws from the power supply. Once this is done, lift up the power supply up at a slight angle to clear the chassis mounting holes on the monitor chassis for removalholes.