Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #12

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Remove the power supply
[* icon_caution] '''''If you see bulged capacitors, treat the power supply as if the capacitors are holding a residual charge.'''''
[* icon_caution] '''''In most cases, the filter capacitor is okay. It MUST be discharged if being replaced.'''''
[* icon_caution] '''''The
replaced. In addition, the black screw (marked in BlueBlue marker) is a groundgrounding screw and only fits here. DO NOT LOSE ITcannot be lost.'''''
[* icon_caution] '''''In most cases, the filter capacitor is okay. It MUST be discharged if being replaced.'''''
[* icon_caution] '''''The
replaced. In addition, the black screw (marked in BlueBlue marker) is a groundgrounding screw and only fits here. DO NOT LOSE ITcannot be lost.'''''
[* icon_reminder] Only lift the power supply board at a slight angle. Lifting it any more then this could result in pin or video processing board damage.
[* icon_reminder] If you cannot find the original capacitors, it is safe to substitute for '''''greater value parts.''''' '''''It is not necessary to match the capacitors used by the factory.'''''
[* red] This capacitor is only used on older power supply boards. '''''If your board has this capacitor, replacement is recommended, but not required unless there is obvious bulging or leakage.'''''
[* black] With the power supply shield removed from the monitor, identify the power supply. Along with the capacitors previously mentioned, take note of any additional capacitors that were not mentioned (Ex: inverter coil).
[* black] Remove the 4 screws from the power supply. Once this is done, lift the power supply up at a slight angle to clear the mounting holes on the monitor chassis for removal.