Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #12

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Identify the power supply
[* icon_caution] '''If any of the capacitors have bulged, they probably haveassume there is a residual chargecharge remaining. Handle the power supply with cautionby the sides and assume there is a residual chargedo not touch the capacitor leads, and use extreme caution.'''
[* black] With the power supply shield removed from the monitor, identify the power supply. Write down the uF and voltageTake a note of the original capacitors and bring this list to an electronics store or buy replacements for all capacitors.the caps you need online.
[* icon_reminder]
'''If you cannot find the original capacitorscapacitors or they cost too much and a higher capacity equivalent is available for less, you can use capacitorssubstitute the originals for ones with a higher voltage and uF rating, as long as they fit. It is very likely you will have tofit the board.'''
[* red] Thisicon_note] The capacitor was phased outmarked in red is only on laterolder power supplies and is not always requiredsupply boards. If you have this capacitora newer board, it also needsis very unlikely to be replacedhave this capacitor in place. If you have it, you will need to replace it as well.
[* icon_note] You only likely need to change the following capacitors: 2x 25V 1000uF, 1x 10V 1000uF, 2x 25V 220uF. However,If any additional capacitors are bad or you wish to change all of the small caps, take note of the other capacitorscaps you may also be bad and need replacement in some cases. Thewish to replace. Replacement of the filter capacitor is usually okay and does not needshould be limited to cases where it has to be replaced if it is in specchanged only, due to the cost.
[* icon_caution] '''If any of the capacitors have bulged, they probably haveassume there is a residual chargecharge remaining. Handle the power supply with cautionby the sides and assume there is a residual chargedo not touch the capacitor leads, and use extreme caution.'''
[* black] With the power supply shield removed from the monitor, identify the power supply. Write down the uF and voltageTake a note of the original capacitors and bring this list to an electronics store or buy replacements for all capacitors.the caps you need online.
[* icon_reminder]
'''If you cannot find the original capacitorscapacitors or they cost too much and a higher capacity equivalent is available for less, you can use capacitorssubstitute the originals for ones with a higher voltage and uF rating, as long as they fit. It is very likely you will have tofit the board.'''
[* red] Thisicon_note] The capacitor was phased outmarked in red is only on laterolder power supplies and is not always requiredsupply boards. If you have this capacitora newer board, it also needsis very unlikely to be replacedhave this capacitor in place. If you have it, you will need to replace it as well.
[* icon_note] You only likely need to change the following capacitors: 2x 25V 1000uF, 1x 10V 1000uF, 2x 25V 220uF. However,If any additional capacitors are bad or you wish to change all of the small caps, take note of the other capacitorscaps you may also be bad and need replacement in some cases. Thewish to replace. Replacement of the filter capacitor is usually okay and does not needshould be limited to cases where it has to be replaced if it is in specchanged only, due to the cost.