Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #12

Edição por Nick

Edição aprovada por Nick

Antes
Depois
Sem alteração

Linhas de Passo

[title] Identify the power supply
[* icon_caution] '''If any of the capacitors have bulged, they probably have a residual charge leftcharge. Handle the power supply with extreme caution and assume there is a residual charge left!charge.'''
[* black] With the power supply shield removed from the monitor, identify the power supply. Write down the uF ratings and voltagesvoltage of the original capacitors and buy replacements for all capacitors. Replace all of the capacitors on the board now. '''If you cannot find the original capacitors, double theyou can use capacitors with a higher voltage and uF ratings to the closetrating, as long as they fit. It is very likely you see for sale. DO NOT double the voltage whatsoever.'''will have to.'''
[* red] This capacitor was phased out on later power supplies and is not always required. If you have this capacitor, it also needs to be replaced.

[* icon_note] You should only concernlikely need to change the capacitors of these ratingsfollowing capacitors: 2x 25V 1000uF, 1x 10V 1000uF, 2x 25V 220uF. The rest are usually fine but if they are off looking replace them. IfHowever, the uF rating is doubled you have to exceed the original capacitors. You cannot go under. Going under will end up causing the newother capacitors to fail when you turn the monitor on.
[* icon_reminder] Regarding the filter capacitor: You can replace the
may also be bad and need replacement in some cases. The filter capacitor on the AC/primary side if you want. This capacitoris usually okay and does not require replacement andneed to be replaced if it is the most expensive. You will also probably find yourself doubling the original capacitors since the Acer rated ones are hard to find. Your mileage on matching the originals will varyin spec.
[* icon_caution] '''If any of the capacitors have bulged, they probably have a residual charge leftcharge. Handle the power supply with extreme caution and assume there is a residual charge left!charge.'''
[* black] With the power supply shield removed from the monitor, identify the power supply. Write down the uF ratings and voltagesvoltage of the original capacitors and buy replacements for all capacitors. Replace all of the capacitors on the board now. '''If you cannot find the original capacitors, double theyou can use capacitors with a higher voltage and uF ratings to the closetrating, as long as they fit. It is very likely you see for sale. DO NOT double the voltage whatsoever.'''will have to.'''
[* red] This capacitor was phased out on later power supplies and is not always required. If you have this capacitor, it also needs to be replaced.

[* icon_note] You should only concernlikely need to change the capacitors of these ratingsfollowing capacitors: 2x 25V 1000uF, 1x 10V 1000uF, 2x 25V 220uF. The rest are usually fine but if they are off looking replace them. IfHowever, the uF rating is doubled you have to exceed the original capacitors. You cannot go under. Going under will end up causing the newother capacitors to fail when you turn the monitor on.
[* icon_reminder] Regarding the filter capacitor: You can replace the
may also be bad and need replacement in some cases. The filter capacitor on the AC/primary side if you want. This capacitoris usually okay and does not require replacement andneed to be replaced if it is the most expensive. You will also probably find yourself doubling the original capacitors since the Acer rated ones are hard to find. Your mileage on matching the originals will varyin spec.

Imagem 1

Versão Antiga

Nova Versão