Alterações no passo nº 5
Edição por Sarah Westberg —
Edição aprovada por Sarah Westberg
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* red] Unscrew the nut holding the fan in place and remove all hardware from the threaded shaft. |
|---|---|
| - | [* icon_reminder] There should be a nylon-insert lock nut, a flat washer and a split ring washer. Set these aside in a safe location. |
| - | [* icon_note] Use a 13mm socket wrench to do this, with an extension to reach the nut if necessary. |
| + | [* red] Use a 13 mm socket wrench with an extension to remove the nut holding the fan in place. Remove all hardware from the threaded shaft. |
| + | [* icon_reminder] There should be a nylon-insert lock nut, a flat washer, and a split ring washer. Set these aside in a safe location. |