Ir para o conteúdo principal

Alterações no passo #14

Edição por Joris Ott

Aguardando aprovação

Sem alteração

Linhas de Passo

[* black] Lift the side of the logic board opposite the ports out of the upper case.
[* black] Rotate the logic board away from the upper case until the ports clear the lip molded in the upper case.
[* black] Pull the logic board and DC-In board away from the edge of the upper case as one piece.
[* icon_reminder] The DC-In board may get accidentally disconnected during this process. As a precaution, be sure the DC-In board connector is securely seated in its socket before lowering the logic board back into the upper case.
[* icon_reminder] Before lowering the logic board back into the upper case, be sure the left speaker and microphone cables are seated in their channels cut into the upper case (as seen in the third picture).
+[* black] Also be sure that all (10) connection cables which later will be connected to the logic board are visible and on the top of the logic board before you fix it.