Conserte seus objetos Comunidade Loja

Alterações no passo nº 7

Edição por Orrett Bailey —

Edição aprovada por Orrett Bailey

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Match the wires from the wall and from the new sensor (the black striped goes with the black striped wire) and connect them with the crimp by inserting two like-kind wires in one crimp with one wire going into each side. Then, use the pair of pliers to press down on the round section of the crimp to seal the connection. Repeat for the other wire.
+[* red] Match the wires from the wall and from the new sensor (the black striped goes with the black striped wire) and connect them with the crimp by inserting two like-kind wires in one crimp with one wire going into each side. Then, use the pair of pliers to press down on the round section of the crimp to seal the connection. Repeat for the other wire.