Ir para o conteúdo principal

Alterações no passo #2

Edição por Andrew Bookholt

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Carefully lay the iMac stand-side down on a flat surface.
[* icon_note] Due to tight tolerances, you will have to use a thin hooked tool to lift the display out of the outer case. As seen in the third picture, we made one out of a bent paperclip.
[* black] Use a thin hooked tool to lift one side of the top edge of the display by its steel outer frame.
[* icon_note] After lifting the top edge of the display on one side, hold it out of the outer case while you use a hooked tool to lift the other side.
[* icon_caution] Do not lift the top edge of the display out of the outer case too far, as several short ribbon cables still connect the two components.

Imagem 1

Nenhuma imagem anterior

Adicionado

Imagem 2

Nenhuma imagem anterior

Adicionado

Imagem 3

Nenhuma imagem anterior

Adicionado