Alterações no passo nº 7
Edição por Elizabeth Eckes —
Edição aprovada por Elizabeth Eckes
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* icon_caution] Verify the circuit board does not have any current supplied to it prior to performing next steps. If current is present, permanent damage to the multimeter is possible! |
|---|---|
| + | [* icon_caution] Verify the circuit board does not have any current supplied to it prior to performing the next steps. If a current is present, permanent damage to the multimeter is possible! |
| [* black] Connect the black probe to the circuit board rail where one end of the solder bridge was. | |
| [* black] Connect the red probe to the circuit board rail where the other end of the solder bridge was. | |
| [* black] If the fix is successful, the multimeter should give a numerical readout on the multimeter screen. This means the rails are no longer connected. | |
| [* icon_note] If the fix was unsuccessful, the multimeter should read "OL" on the screen, indicating an open circuit. |