Alterações no passo nº 7
Linhas do passo
| [* icon_caution] Verify the circuit board does not have any current supplied to it prior to performing next steps. If current is present, permanent damage to the multimeter is possible! | |
| [* black] Connect black probe to the circuit board rail where the solder bridge was. | |
| [* black] Connect red probe to the circuit board rail above where the solder bridge was. | |
| [* black] If the fix is successful, the multimeter should give a numerical readout on the multimeter screen. | |
| - | [* icon_note] If the fix was unsuccessful, the multimeter should read "OL" on the screen, indicating an open circuit. |
| + | [* icon_note] If the fix was unsuccessful, the multimeter should read "OL" on the screen, indicating an open circuit and an audible beeping sound will be emitted by the multimeter. |