Alterações no passo nº 7
Edição por Curt Reitenbach —
Edição aprovada por Curt Reitenbach
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Connect Multimeter to Repaired Solder Bridge. |
|---|---|
| - | [* icon_caution] Verify the circuit board does not have any current supplied to it prior to performing next steps. If current is present, permanent damage to the multimeter is possible! |
| - | [* black] Connect black probe to the circuit board where the solder bridge was. |
| - | [* black] Connect red probe to the circuit board above where the solder bridge was. |
| + | [* icon_caution] Verify the circuit board does not have any current supplied to it prior to performing next steps. If current is present, permanent damage to the multimeter is possible! |
| + | [* black] Connect black probe to the circuit board where the solder bridge was. |
| + | [* black] Connect red probe to the circuit board above where the solder bridge was. |
| [* black] If the fix is successful, the multimeter should give a numerical readout on the multimeter screen. | |
| [* icon_note] If the fix was unsuccessful, the multimeter should read "OL" on the screen, indicating an open circuit. |