Conserte seus objetos Comunidade Loja

Alterações no passo nº 7

Edição por Curt Reitenbach —

Edição aprovada por Curt Reitenbach

Antes
Depois
Sem alteração

Linhas do passo

[* black] Connect Multimeter to Repaired Solder Bridge.
- [* black] NOTE: Verify the circuit board does not have any current supplied to it prior to performing next step.
+ [* icon_note] Verify the circuit board does not have any current supplied to it prior to performing next step.
[* black] Connect black probe to the circuit board where the solder bridge was.
[* black] Connect red probe to the circuit board above where the solder bridge was.
-[* black] If the fix is successful, the multimeter should give a numerical reading on the screen.
- [* black] If the was unsuccessful, the multimeter should make an audible beeping noise, indicating
+[* black] If the fix is successful, the multimeter should give a numerical reading on the multimeter screen.
+ [* black] If the repair was unsuccessful, the multimeter should read "OL" on the screen, indicating an open circuit.