Conserte seus objetos Comunidade Loja

Alterações no passo nº 7

Edição por Curt Reitenbach —

Edição aprovada por Curt Reitenbach

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Verify solder bridge is repaired.
+[* black] Connect Multimeter to Repaired Solder Bridge.
[* black] NOTE: Verify the circuit board does not have any current supplied to it prior to performing next step.
[* black] Connect black probe to the circuit board where the solder bridge was.
[* black] Connect red probe to the circuit board above where the solder bridge was.
+[* black] If the fix is successful, the multimeter should give a numerical reading on the screen.
+ [* black] If the was unsuccessful, the multimeter should make an audible beeping noise, indicating