Alterações no passo nº 6
Edição por Elizabeth Eckes —
Edição aprovada por Elizabeth Eckes
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Connect red (positive) probe to the Voltage and Resistance Socket. |
|---|---|
| - | [* black] Connect black (negative) probe to the Common/Ground Socket. |
| - | [* black] Set the multimeter knob for continuity testing |
| + | [* black] Connect the red (positive) probe to the Voltage and Resistance Socket. |
| + | [* black] Connect the black (negative) probe to the Common/Ground Socket. |
| + | [* black] Set the multimeter knob for continuity testing. This is typically labeled with diode/audio symbols. |
| [* icon_note] As shown in the photo, the multimeter will read "OL" if the steps above have been followed properly. | |
| [* black] To ensure the functionality of the multimeter, touch the two probes together and an audible beeping sound should be emitted. |