Histórico do passo nº 6 do guia How to Fix a Solder Bridge

Alterações no passo nº 6

Edição por Steven — 10 de mai de 2023

Edição aprovada por Steven

	[* black] Connect red (positive) probe to the Voltage and Resistance Socket.
	[* black] Connect black (negative) probe to the Common/Ground Socket.
-	[* black] ~~Turn~~ knob ~~of multimeter to the Diode and Capacitance Test Setting~~.
+	[* black] Set the multimeter knob for continuity testing, typically labeled with diode/audio symbols.
	[* icon_note] As shown in the photo, the multimeter will read "OL" if the steps above have been followed properly.
-	[* black] Touch the tip of the probes together to verify the multimeter is functioning properly.
-	[* icon_note] Upon completing this step above, the multimeter should read a number less than 1. The photo in the guide does not depict this.
+	[* black] To ensure the functionality of the multimeter, touch the two probes together and an audible beeping sound should be emitted.