Conserte seus objetos Comunidade Loja

Alterações no passo nº 6

Edição por Curt Reitenbach —

Edição aprovada por Curt Reitenbach

Antes
Depois
Sem alteração

Linhas do passo

[* black] Set up the multimeter:
- [* black] Connect red (positive) probe to the Voltage and Resistance Socket.
- [* black] Connect black (negative) probe to the Common/Ground Socket.
- [* black] Turn knob of multimeter to the Diode and Capacitance Test Setting.
- [* black] The multimeter will read "OL" if the steps have been followed properly.
- [* black] Touch the tip of the probes together to verify the multimeter is functioning properly.
-[* icon_note] Upon completing the steps above, the multimeter should read a number less than 1. The photo in the guide does not depict this.
+[* black] Connect red (positive) probe to the Voltage and Resistance Socket.
+[* black] Connect black (negative) probe to the Common/Ground Socket.
+[* black] Turn knob of multimeter to the Diode and Capacitance Test Setting.
+ [* icon_note] As shown in the photo, the multimeter will read "OL" if the steps above have been followed properly.
+[* black] Touch the tip of the probes together to verify the multimeter is functioning properly.
+ [* icon_note] Upon completing this step above, the multimeter should read a number less than 1. The photo in the guide does not depict this.