Alterações no passo nº 6
Edição por Curt Reitenbach —
Edição aprovada por Curt Reitenbach
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Set up the multimeter: | |
| [* black] Connect red (positive) probe to the Voltage and Resistance Socket. | |
| [* black] Connect black (negative) probe to the Common/Ground Socket. | |
| [* black] Turn knob of multimeter to the Diode and Capacitance Test Setting. | |
| - | [* black] NOTE: Upon completing the steps above, the multimeter should read "OL" as shown in the picture. |
| + | [* black] Touch the tip of the probes together to verify the multimeter is functioning properly. |
| + | [* black] NOTE: Upon completing the steps above, the multimeter should read a number less than 1. The photo in the guide does not depict this. |